During your travels around Arda, you will come across many books on
various subjects. Most of them share the same syntax for reading; this
help file describes it in detail.
read <book> -
Starts reading a given book. Standard command parsing applies, that
is "book 2", "my book", "book on ground", etc. will work. This will
set the book as your "current book".
read page <nr> of <book> -
Reads a specific page of a given book. Similarly to above command,
standard command parsing applies. This also sets the book as your
"current" one.
read page <nr> -
Reads a specific page of your "current" book. This command will fail
if you didn't designate any "current" book with one of the commands
mentioned above.
read next page -
Reads next page in your "current" book.
read previous page -
Reads previous page in your "current" book.
